Idiomas disponibles
Idiomas disponibles
NOTICE:
Before each use, inspect the entire product for damaged,
missing, or loose parts such as screws, nuts, bolts, caps,
etc. Tighten securely all fasteners and caps and do not
operate this product until all missing or damaged parts
are replaced. Inspect the machine for damage upon
striking a hard object or if there appears to be excessive
vibration. Please contact customer service or an autho-
rized service center for assistance.
CHARGING THE TOOL
See Figure 5.
Make sure the switch trigger is locked out in the off
position.
Insert the charging cable into the product as shown.
Connect the power adapter to an outlet providing normal
household voltage, 120 volts, AC only, 60 Hz.
When the tool is charging, the LED will turn red.
Do not place tool in an area of extreme heat or cold. It
will charge best at normal room temperature.
If the LED does not turn on after connecting to a power
supply, check connections. If all connections are secure,
remove from power supply and recheck after one hour.
After charging is complete, the LED will turn green.
If LED does not turn to green after three hours, an error
has occured. If all connections are secure, remove from
power supply and recheck after one hour.
Disconnect the power adaptor from the outlet once the
tool is fully charged and ready for use.
Disconnect the charging cable from the tool.
WARNING:
Battery tools are always in operating condition. Therefore,
switch should always be locked with hands free of the
lock-out trigger when not in use.
WARNING:
Do not use charger outdoors or expose to wet or damp
conditions. Water entering charger will increase the risk
of electric shock.
WARNING:
Do not charge the battery in a damp or wet location. Do
not use, store, or charge battery packs or products in
locations where the temperature is less than 50°F or more
than 100°F. Do not store outside or in vehicles.
OPERATION
STARTING/STOPPING THE LAWN TRIMMER
See Figure 6.
To start the lawn trimmer, push the lock-out trigger and
pull the switch trigger.
To stop the lawn trimmer, release the switch trigger.
OPERATING THE TRIMMER
See Figure 7.
Follow these tips when using the lawn trimmer:
Hold the trimmer with your right hand on the rear handle
and your left hand on the front handle.
Keep a firm grip with both hands while in operation.
Trimmer should be held at a comfortable position with
the rear handle about hip height.
Cut tall grass from the top down. This will prevent grass
from wrapping around the boom housing and string head
which may cause damage from overheating.
If grass becomes wrapped around the string head:
Make sure the switch trigger is locked out in the off posi-
tion.
Remove the grass.
WARNING:
Always hold the lawn trimmer away from the body keep-
ing clearance between the body and the lawn trimmer.
Any contact with the lawn trimmer cutting head while
operating can result in serious personal injury.
CUTTING TIPS
See Figure 8.
This product is designed to cut small weeds, grass or
similar soft vegetation.
Keep the trimmer tilted toward the area being cut; this is
the best cutting area.
The lawn trimmer cuts when passing the unit from right to
left. This will avoid throwing debris at the operator. Avoid
cutting in the dangerous area shown in figure 8.
Use the tip of the line to do the cutting; do not force string
head into uncut grass.
Wire and picket fences cause extra line wear, even
breakage. Stone and brick walls, curbs, and wood may
wear line rapidly.
Avoid trees and shrubs. Tree bark, wood moldings, siding,
and fence posts can easily be damaged by the line.
Page 8
