Idiomas disponibles
Idiomas disponibles
WARNING
battery pack from the tool when cleaning or
performing any maintenance.
SERVICE
WARNING
unauthorized personnel may result in
misplacing of internal wires and
components which could cause a serious
hazard. We recommend that all tool service be
performed by a FLEX Factory Service Center or
Authorized FLEX Service Station.
GENERAL MAINTENANCE
WARNING
parts. Use of any other parts could create a
hazard or cause product damage. Periodically
inspect the entire product for damaged, missing,
or loose parts such as screws, nuts, bolts, caps,
PULLEY BRUSH (FIG. 11)
The pulley brush is located inside the saw
housing next to the drive pulley and helps keep
the blade clean of dust and chips. As the brush
becomes worn, it will need to be adjusted or
replaced.
1. Turn the band saw over and place it on a
workbench or table with the front handle to
the right.
2. Lift both blade cover locks and open the blade
cover.
3. Loosen the screw that secures the pulley
brush with a T20 Torx screwdriver (not
included).
4. Position the pulley brush against the pulley.
5. Tighten the screw.
6. Close the blade cover and press down the
blade cover locks.
STORAGE
Store the tool indoors in a place that is
inaccessible to children. Keep away from
corrosive agents.
MAINTENANCE
To avoid serious personal
injury, always remove the
Preventive maintenance
performed by
When servicing, use only
identical replacement
etc. Tighten securely all fasteners and caps and
do not operate this product until all missing or
damaged parts are replaced. Please contact
customer service or an authorized service
center for assistance.
WARNING
compressed dry air. Always wear safety
goggles when cleaning tools with
compressed air. Ventilation openings and
switch levers must be kept clean and free of
foreign matter. Do not attempt to clean by
inserting pointed objects through openings.
WARNING
plastic parts. Some of these are: gasoline,
carbon tetrachloride, chlorinated cleaning
solvents, ammonia and household detergents
that contain ammonia.
Fig. 11
Screw
Drive Pulley
-19-
CLEANING
The tool may be cleaned
most effectively with
Certain cleaning agents
and solvents damage
Pulley Brush
