Becken BBIDW5370 Manual De Instalación página 16

Idiomas disponibles

2 Pour the rinse aid into the dispenser but be careful not to overfill.

3 Replace the cap by inserting it aligned with the "open" arrow and turn

it in the direction of the "closed" arrow (right).

This dishwasher is designed to use liquid rinse aids, and the rinse aid

dispenser is located inside the door next to the detergent dispenser.

The rinse aid is released during the final rinse to prevent water from

forming droplets, which can leave spots and streaks on your dishes. It

also improves drying by allowing water to sheet off the dishes.

To fill the dispenser, open the cap and pour the rinse aid into the

dispenser until the level indicator goes completely off. Please be

aware that the volume of the rinse aid container is about 140 mL,

so please be careful not to overfill the dispenser as this could cause

over spilling. Wipe away any spills with a damp cloth. Do not forget to

reinsert the cap before you close the dishwasher's door.

Attention!

Clean up any rinse aid spilled during filling with an absorbent cloth to

avoid excess foaming during the next wash.

Adjusting Rinse Aid Dispenser

Adjust lever

(Rinse)

NOTE: Increase the dose if there are drops of water or lime spots on

the dishes after washing. Reduce it if there are sticky whitish streaks on

the dishes or a bluish film on glassware or knife blades.

AF MANUAL MÁ Q . LOIÇ A ENCASTRE BBIDW5370 A5 (2).indd 16

The rinse aid dispenser has four or six settings,

but it is recommended to always start with the

dispenser set on "4". If spots and poor drying

are a problem, increase the amount of rinse aid

dispensed by removing the dispenser lid and

rotating the dial to "5". If the dishes still do not dry

properly or have spots, adjust the dial to the next

higher number until they are spot-free. The dose

is factory set in the position 5.

08/09/2020 12:09