Idiomas disponibles
Idiomas disponibles
ANCHORING
IMPORTANT! Ensure the floor surface is level
before anchoring.
NOTE: Shims may be used on the underside of
the base frame if concrete is not level.
1.
Drill holes through the base frame and into floor at
each corner of the base frame. (See Figure 6)
NOTE: For H-10647, holes in base frame are
pre-drilled.
NOTE: If necessary, mark the holes drilled in
the base frame as a template and move table
with a forklift to allow room for drilling into floor.
When complete, reposition the table.
Figure 6
WARNING! Wear appropriate personal
protective equipment such as safety shoes
when operating.
WARNING! Never overload table. Stay within
rated capacity. Do not die or end load. Load
must be distributed on at least 80 percent of
table area.
IMPORTANT! Before raising or lowering the
platform, ensure people and objects are clear
of the table. If platform is loaded, recheck
position and condition of the load.
1.
Press the "Up" button to raise the platform. If load
appears to be shifting, stop, lower the platform and
adjust load. (See Figure 8)
Figure 8
Emergency Stop
PAGE 3 OF 17
INSTALLATION CONTINUED
Base
Frame
Power
Up
Down
2. Assemble one washer and nut on anchor bolt. Screw
the nut onto the anchor bolt.
3. Drive the assembled anchor through the previously
drilled hole and into the concrete. The washer
should be flush with the top of the base plate.
Tighten the nut three to five turns to secure.
Repeat for remaining three anchors. (See Figure 7)
Figure 7
OPERATION
2. Press the "Down" button to lower the platform. Watch
the condition of the load as the platform is lowering.
If the load appears to be shifting, stop and adjust
the load.
CAUTION! If the safety border is engaged, the
safety protection switch will be activated and
the platform cannot lower. To disengage the
safety border, follow steps 3 and 4 before
lowering the platform. (See Figure 9)
Safety Protection
Figure 9
3. Press "Up" and let platform slightly raise.
4. Press "Down" and then the platform can be lowered
normally.
Concrete
Anchor
Switch
Safety Border
0323 IH-10646
