Idiomas disponibles
Idiomas disponibles
User manual
Spot
Welding
time
pulse (s)
Spot
Back to menu
welding time
Setup
(s)
Duration
between
2 points (s)
Back to menu
Setup
Man = Manual
OPTIONAL COOLING UNIT
Reference
Product Name
070820
KOOLWELD 1
The cooling unit is automatically detected by the machine.
SEt
UP
In the menu
Co.U.
On
: the cooling unit is always running.
Co.U. OFF
: the cooling unit can be deactivated in TIG mode.
Co.U. Auto
: activation of the cooling unit during welding and deactivation 10 minutes after the end of welding.
The safety features supported by the cooling unit, to ensure the protection of the user and the torch, are as follows:
• Minimum coolant level.
• Minimum flow rate of coolant flowing through the torch.
• Thermal protection of the coolant.
Make sure that the cooling unit is switched off before disconnecting the inlet and outlet hoses for torch liquid.
Coolant is harmful and irritates the eyes, mucous membranes and skin. Hot liquid may cause burns.
CALIBRATION
This mode is dedicated to the calibration of the welding accessories such as the torch, or earth clamp and cable.
The purpose of calibration is to compensate for variations in accessory lengths, so as to adjust the displayed voltage measurement and improve the
energy calculation.
Access to calibration is done in the menu
C.C. ACC.
The first step
collet holder and the ground clamp or directly on the workpiece. Once the short circuit has been made, confirm with the thumbwheel.
The second stage begins, and a progress bar
initiates the flow of the calibration current.
If the procedure was successful, the machine exits calibration mode automatically, along with a brief overview of the resistance value of the acces-
sory. This value is now reflected in the voltage display and the energy calculation.
If unsuccessful, the menu exits automatically and displays a long
the calibration must be redone.
Translation of the original
instructions
VaL
t.PL
VaL
t.dC
VaL
t.MU.
Cooling power
1,000 W
Con
FIG.
SEt
UP
requires short-circuiting the accessories. In TIG, it is recommended that the short circuit be made between the
CaL.
I I I
60.0
Man
t.PL
Man
t.dC
60.0
0.1
t.MU.
Capacity
Power supply voltage
3 L
24 V DC
CaL
Ibr.
is displayed on the HMI of the power source. Pressing a button on the torch
CaL.
no
. If the operation fails, the circuit was not done correctly and
TITAN 231 DC FV
t.PL
t.dC
Validation of
the current
setting
25
t.MU.
Validation of
the current
setting
43
