Idiomas disponibles
Idiomas disponibles
9. SWING Button
Use the SWING button to initiate the
auto swing feature for the outlet louver.
When the auto swing is on, pressing the
SWING button can stop the louver at the
desired angle.
Check Filter Feature:
The Check Filter feature is a reminder
to clean the air filter for a more
efficient operation. The light above the
button will illuminate after 250 hours
of operation. After cleaning the filter,
press the SWING button for 3 seconds
to reset the Check Filter feature turning
the light off.
10. MShield feature
Press SWING button and SLEEP button
at the same time for 3 seconds to initiate
MShield feature and the MShield light
illumiantes, the LED DISPLAY shows 'On'
for 3 seconds for some units. Press it for
3 seconds again to stop the MShield
feature and the MShield light turn dark,
the LED DISPLAY shows 'OF' for
3 seconds for some units.
DISPLAYS
LED Display:
Shows the set temperature in "°C" or
"°F" and the Auto-timer settings. While
on Fan Only mode, it shows the room
temperature. If the room temperature is
too high or low, it will display " HI" or " LO".
To change between °F and °C, press and
hold the UP (
) and DOWN (
at the same time for 3 seconds.
Display
Page 12
Error codes:
The unit may stop operation due to a
malfunction with the unit. If this occurs,
an error code may appear on the display
like below.
Wait 10 minutes as the problem may
resolve itself. If not, disconnect the
power, then connect it again. Turn the
unit on.
If the problem persists, disconnect the
power and contact customer service.
Error code appears and begins with the
letters as the following in the window
display of indoor unit:
EH(xx), EL(xx), EC(xx) , PH(xx), PL(xx),
PC(xx).
NOTICE
If the unit turns off unexpectedly due to
the power being cut, it will automatically
restart with the previous function setting
when the power resumes.
) buttons
