Idiomas disponibles
Idiomas disponibles
Check the parts
Name
Main bracket
Stand
Prepare a Phillips screwdriver beforehand.
Install the main bracket
Align t he main bracket over t he screw holes on t he st and. Then f ast en
t he main bracket t o t he st and using 10 count ersink screw s.
Be sure that two or more persons hold the parts during this procedure.
Tighten the 10 countersink screws once again after screwing them temporarily.
Note
Be sure to hold the stand firmly and keep it stable.
Caution
When using an electric screwdriver, set the
torque setting to about 2.45N·m.
Do not use an impact driver. If you use an
impact driver or an electric screwdriver with
the torque setting out of the specified range,
screws may be excessively tightened, which
may damage the screws or product. The
stand may fall and serious injury may result.
6
(US)
Downloaded from:
https://www.usersmanualguide.com/
Quantity
Name
Countersink screw
1
Securing screw
1
Cable clamper
Count ersink
screw s
M ain bracket
St and
Quantity
10
2
1
