Idiomas disponibles
Idiomas disponibles
p) Do not use accessories that
require liquid coolants. Using
water or other liquid coolants
may result in electrocution or
shock.
KICKBACK AND RELATED
WARNINGS
Kickback is a sudden reaction to a
pinched or snagged rotating wheel,
backing pad, brush or any other
accessory. Pinching or snagging
causes rapid stalling of the rotating
accessory which in turn causes the
uncontrolled power tool to be forced
in the direction opposite of the
accessory's rotation at the point of
the binding.
For example, if an abrasive wheel
is snagged or pinched by the
workpiece, the edge of the wheel
that is entering into the pinch point
can dig into the surface of the
material causing the wheel to climb
out or kick out. The wheel may
either jump toward or away from the
operator, depending on direction of
the wheel's movement at the point of
pinching. Abrasive wheels may also
break under these conditions.
Kickback is the result of power tool
misuse and/or incorrect operating
procedures or conditions and
can be avoided by taking proper
WWW.SENIXTOOLS.COM
precautions as given below.
a) Maintain a firm grip on the
power tool and position your
body and arm to allow you
to resist kickback forces.
Always use auxiliary handle,
if provided, for maximum
control over kickback or
torque reaction during start-
up. The operator can control
torque reactions or kickback
forces, if proper precautions are
taken.
b) Never place your hand near
the rotating accessory.
Accessory may kickback over
your hand.
c) Do not position your body in
the area where power tool
will move if kickback occurs.
Kickback will propel the tool in
direction opposite to the wheel's
movement at the point of
snagging.
d) Use special care when
working corners, sharp
edges etc. Avoid bouncing
and snagging the accessory.
Corners, sharp edges or
bouncing have a tendency to
snag the rotating accessory
and cause loss of control or
kickback.
e) Do not attach a saw chain
9 - EN
