tool. Read all safety warnings,
instructions, illustrations
and specifications provided
with this power tool. Failure
to follow all instructions listed
below may result in electric
shock, fire and/or serious injury.
b) Operations such as
sanding,wire brushing,
polishing are not
recommended to be
performed with this power
tool. Operations for which the
power tool was not designed
may create a hazard and cause
personal injury.
c) Do not use accessories which
are not specifically designed
and recommended by the tool
manufacturer. Just because
the accessory can be attached
to your power tool, it does not
assure safe operation.
d) The rated speed of the
accessory must be at least
equal to the maximum speed
marked on the power tool.
Accessories running faster than
their rated speed can break and
fly apart.
e) The outside diameter and the
thickness of your accessory
must be within the capacity
rating of your power tool.
WWW.SENIXTOOLS.COM
Incorrectly sized accessories
cannot be adequately guarded
or controlled.
f) Threaded mounting of
accessories must match
the grinder spindle thread.
For accessories mounted
by flanges, the arbour hole
of the accessory must fit
the locating diameter of the
flange. Accessories that do not
match the mounting hardware
of the power tool will run out of
balance, vibrate excessively and
may cause loss of control.
g) Do not use a damaged
accessory. Before each use
inspect the accessory such
as abrasive wheels for chips
and cracks, backing pad
for cracks, tear or excess
wear, wire brush for loose or
cracked wires. If power tool
or accessory is dropped,
inspect for damage or install
an undamaged accessory.
After inspecting and installing
an accessory, position
yourself and bystanders
away from the plane of the
rotating accessory and run
the power tool at maximum
no-load speed for one minute.
Damaged accessories will
7 - EN