Health O Meter 499KL Manual Del Usuario página 10

SET UP INSTRUCTIONS
Auto Off Function
When powering the scale via the AC adapter, the display can be set to power off after a
period of inactivity. The Auto Off default setting is "disabled". Follow this procedure to
enable or disable the Auto Off function. Note: When powering the scale via batteries,
the Auto Off function is automatically enabled.
Enable / Disable Auto Off
1. While the scale is turned off, press and hold the ENTER button then press and
release the ON/OFF button. Hold the ENTER button until "AOF=d" or "AOF=E"
appears on the display, then release. Press the ENTER button again to change the
setting.
AOF=d Disables the Auto Off function
AOF=E Enables the Auto Off function
2. Press CLEAR to save your selection and exit the Options mode.
3. The scale will restart. The display will show "UEr", followed by a version number,
and then dashes. When the display shows "0.0" the scale is ready to use.
Setting Auto Off Time
When powering the scale via batteries or if Auto Off is Enabled for the AC adapter, the
period of inactivity before the scale powers off can be set to a specific amount of time. The
default setting for Auto Off time is 2 minutes. Follow this procedure to set the number of
minutes of inactivity before power off.
1. While the scale is turned off, press and hold the ENTER button then press and
release the
ON/OFF button. Hold the ENTER button until "AOF=d" or "AOF=E" appears on the
display, then release. Use the ▲ or ▼ buttons to advance the display screen until
"AFt" appears. Press the ENTER button to change the Auto Off time.
AFt = 1 Scale will power off after 1 minute of inactivity
AFt = 2 Scale will power off after 2 minutes of inactivity
AFt = 3 Scale will power off after 3 minutes of inactivity
2. Choose the setting you prefer and press CLEAR to save your selection and exit the
Options mode.
3. The scale will restart. The display will show "UEr", followed by a version number,
and then dashes. When the display shows "0.0" the scale is ready to use.
Setting Sound Options
The display can be set to stay silent or beep while operating the scale. The default
setting for Sound is "enabled". Follow this procedure to enable or disable sound.
1. While the scale is turned off, press and hold the ENTER button then press and
release the ON/OFF button. Hold the ENTER button until "AOF=d" or "AOF=E"
appears on the display, then release. Use the ▲ or ▼ buttons to advance the display screen until "Snd" appears. Press the ENTER button to change the setting.
Snd = E Enables sound so the scale beeps when keys are pressed.
Snd = d Disables sound so the scale stays silent when keys are pressed.
2. Choose the setting you prefer and press CLEAR to save your selection and exit the
options mode.
3. The scale will restart. The display will show "UEr", followed by a version number,
and then dashes. When the display shows "0.0" the scale is ready to use.
UM499KL REV20210521
10
Back to Home Page