Idiomas disponibles
Idiomas disponibles
STATUS indicator
Update mode
Blinking blue/red (once per second)
STATUS/SAMPLE RATE indicators and, according
Checking device ID
to device ID number, OUTPUT channel LEDs blink
(once per second)
STATUS/SAMPLE RATE indicators and, according
Changing device ID
to device ID number, OUTPUT channel LEDs blink
(twice per second)
STATUS/SAMPLE RATE/PRIMARY/SECONDARY LEDs
Safe mode
blink (once per second)
Rear panel
qRESET button
Pressing the RESET button while the unit is powered and
operating will restore network address settings and all other
unit settings to their factory defaults. (see "Restoring factory
default settings" on page 13)
Left side panel
eAC IN connector
Connect the included power cord here.
Note
The unit firmware is being updated.
This is the state when the device ID set in the unit is
being shown.
This is the state when the device ID set in the unit is
being changed.
The unit is in safe mode.
wGPIO connector
This is a 25-pin D-sub Parallel control input/output
connector.
Use this to connect an external controller. (see "Dante
Controller overview" on page 14)
rEXT DC IN connector
Connect external DC power here.
Use a power supply that has a 11V -27V Limited Power
Source (LPS) rating for output voltage with the EXT DC IN
connector.
The connector is XLR-4-32 equivalent (1: –, 2: NC, 3: NC, 4: +).
tPRIMARY connector
This is the main etherCON Cat5e-compatible Dante
transmission connector.
Use this to connect to a Dante network all the time.
ySECONDARY connector
This is the secondary etherCON Cat5e-compatible Dante
transmission connector. The use changes depending on the
mode.
When in redundant mode, this connects to the secondary
Dante network.
When in switched (daisy chain) mode, use to connect
another Dante device in the chain.
9
TASCAM SB-16D
