Names Of Parts; Front Panel; Rear Panel - Tascam AE-4D Manual Del Usuario

Names of parts

Front panel

STATUS indicator
1
STATUS
The indicator blinks blue under the following
conditions.
o When no LAN cable is connected
o When the Dante module is not operating properly

Rear panel

AES/EBU IN connectors
5
These are balanced XLR AES3-2003/IEC60958-4 (AES/
EBU) format digital audio input connectors.
NOTE
When the sampling frequency is 88.2 or 96 kHz, use the
AES/EBU IN 1-2
connector. The
tor cannot be used.
AES/EBU OUT connectors
6
These are balanced XLR AES3-2003/IEC60958-4 (AES/
EBU) format digital audio output connectors.
NOTE
When the sampling frequency is 88.2 or 96 kHz, use the
AES/EBU OUT 1-2
connector. The
connector cannot be used.
8
TASCAM AE-4D
AES/EBU IN 3-4
connec-
AES/EBU OUT 3-4
SAMPLE RATE indicator
2
The lit/unlit state of the three SAMPLE RATE indicators
(44.1k, 48k and ×2) show the sampling frequency status
of the unit.
44.1 kHz
44.1 kHz Lit
48 kHz Unlit
88.2 kHz Lit
96 kHz Unlit
IN SIG indicators
3
These light when sound is being input through the dig-
ital inputs.
Input is judged to have occurred when the signal level
exceeds −60 dBFS.
OUT SIG indicators
4
These light when sound is being output through the dig-
ital outputs.
Output is judged to have occurred when the signal level
exceeds −60 dBFS.
DC IN/DC OUT connectors
7
The DC-IN connector is above, and the
tor is below. (Left is 12V, and right is GND.)
These connectors are specifically for power daisy-chain-
ing.
ATTENTION
Disconnect the AC adapter before connecting the
DC OUT
and connectors.
NOTE
i Power daisy-chaining can be enabled by connecting the
DC OUT DC IN
and connectors. Power daisy-chaining of
up to two units is possible
i When powering by PoE, the first unit in the powerdai-
sy-chain will not be powered. In this case, use a dedicat-
ed PS-P1220E AC adapter (sold separately) to power the
first unit in the daisy chain.
DATA/DATA+PoE connectors
8
These are Dante transmission connectors.
Use to connect the unit to a Dante network.
Use the DATA+PoE connector when connecting to a
switching hub that supports PoE power supply. In this
case, use of an AC adapter is not necessary.
Either connector can be used when using a switching
hub that does not support PoE power supply.
RESET button
9
This resets the settings.
Press and hold for 5 seconds to reset all Dante settings.
Press and hold for 10 seconds to reset all unit settings.
48 kHz x2
Unlit Unlit
Lit Unlit
Unlit Lit
Lit Lit
DC-OUT
connec-
DC IN