Idiomas disponibles
Idiomas disponibles
//
A S S E M B L Y I N S T R U C T I O N S
6.
1. Assemble the handlebar (79) to the bracket
on the handlebar post
2.Fix the spring washer (7), flat washer (6) and
metal bush (4) into the handlebar clamp.
3.Put the plastic cover(67,3) pressing the
handlebar. Then fix the plastic cover with the
Allen key (68)
4.Fix the knob (5) to the plastic cover,Adjust the
handlebar with your desired angle. Fasten the
T-knob.
//
1 0
5.
"1. Unscrew the pre-locked screws on the console with a
harpoon wrench.
2. Connect the line (2) to the leading wire of the electronic
table (1).
3. Align the holes with the harpoon wrench as shown in
the figure and tighten the screw (83).
4.Take down the screw pre-locked on the handrail riser
and use the harpoon wrench to align the kettle holder
(99) with the hole as shown in the figure, then lock the
screw (68). "
