Idiomas disponibles
Idiomas disponibles
INTEGRATED PROTECTION
The Unipower is equipped with thermal protection and electrical protection against overloads as well as
a low voltage and overvoltage protection.
The inverter turns off:
- when the inner temperature of the inverter is too high
- when the consumption of the connected devices is over the nominal power of the inverter
- when the battery voltage is to low or too high.
TROUBLESHOOTING
UNIPOWER 150.12Q and 150.24Q
Troubleshooting
The blue light is on
"Low battery warning"
The device doesn't turn ON
Causes
Overconsumption or
discharged battery
24V>230V inverter:
Battery not suitable (12V
instead of 24V)
Bad connection
Problem with the vehicle
cigarette lighter
connector
Problem with the inverter
cigarette lighter
connection
Discharged battery
WWW
Solutions
Recharge it and/or reduce the consumption
of the connected devices before the
inverter puts itself in protection mode.
Replace your 12V battery with a 24V battery
Control the cigarette lighter connection.
The cigarette lighter connection fuse of the
vehicle is melted (diagnosis: the cigarette
lighter does not deliver power anymore
and do not heat). Replace the fuse.
Electrical connection problem due to dust
or ashes in the connector (diagnosis: the
cigarette lighter does not deliver power
anymore and heats). Clean the
connections with a plastic brush without
metal in order not to make a short-circuit.
The fuse located in the cigarette lighter
connection melted.
Replace the fuse by another fuse of the
same size.
Recharge your battery or replace it, if it is
defective
.
.
UNITECK
FR
EN
31/68
