Tabla de contenido
Idiomas disponibles
Idiomas disponibles
5.
After tying, be careful not to hook the arm on the
rebars, and then pull the tool up.
Fig.36
CAUTION:
If the wire has clung to the binding
part of the tool tip, turn the power of the tool off.
Lock the trigger, remove the battery cartridge,
and remove the wire using tools such as nippers
or pliers.
Fig.37
Continuous actuation mode
1.
Switch the tool mode from the single actuation
mode to the continuous actuation mode using the mode
switching button.
1
Fig.38
► 1. Mode switching button
2.
Release the trigger lock.
3.
While pulling the switch trigger, push the tool
vertically against the rebars, and press the arm against
the point where the rebars cross at a 45-degree angle.
Press the contact plate firmly against the tying point.
The wire will be tied.
45°
Fig.39
► 1. Contact plate
16 ENGLISH
45°
1
Tabla de contenido
