Adjusting The Miter Angle - Makita LS1221 Manual De Instrucciones

Sierra de inglete mixta
Ocultar thumbs Ver también para LS1221:
Tabla de contenido
Idiomas disponibles

Idiomas disponibles

Adjusting the miter angle

1
► 1. Miter scale 2. Pointer 3. Grip 4. Lock lever
Loosen the grip by turning counterclockwise. Turn the
turn base while pressing down the lock lever. When you
have moved the grip to the position where the pointer
points to the desired angle on the miter scale, securely
tighten the grip clockwise.
CAUTION:
When turning the turn base, be sure to raise the
handle fully.
After changing the miter angle, always secure
the turn base by tightening the grip firmly.
Adjusting the bevel angle
To adjust the bevel angle, loosen the lever at the rear of
the tool counterclockwise.
► 1. Lever
Push the handle to the left to tilt the saw blade until the
pointer points to the desired angle on the bevel scale.
Then tighten the lever clockwise firmly to secure the
arm.
4
2
3
1
► 1. Pointer 2. Bevel scale 3. Lever
CAUTION:
When tilting the saw blade, be sure to raise the handle fully.
After changing the bevel angle, always secure
the arm by tightening the lever clockwise.
When changing bevel angles, be sure to posi-
tion the kerf boards appropriately as explained
in the "Positioning kerf boards" section.
Switch action
WARNING:
Before plugging in the tool, always
check to see that the switch trigger actuates properly
and returns to the "OFF" position when released. Do
not pull the switch trigger hard without pressing in
the lock-off button. This can cause switch breakage.
Operating a tool with a switch that does not actuate prop-
erly can lead to loss of control and serious personal injury.
WARNING:
NEVER use tool without a fully oper-
ative switch trigger. Any tool with an inoperative switch
is HIGHLY DANGEROUS and must be repaired before
further usage or serious personal injury may occur.
WARNING:
NEVER defeat the lock-off button
by taping down or some other means. A switch with
a negated lock-off button may result in unintentional
operation and serious personal injury.
WARNING:
NEVER use the tool if it runs when you
simply pull the switch trigger without pressing the lock-off
button. A switch in need of repair may result in unintentional
operation and serious personal injury. Return tool to a Makita
service center for proper repairs BEFORE further usage.
1
► 1. Switch trigger 2. Lock-off button 3. Hole for padlock
8 ENGLISH
1
2
3
3
2
Tabla de contenido
loading

Tabla de contenido