Makita LS1221 Manual De Instrucciones página 9

To prevent the switch trigger from being accidentally
pulled, a lock-off button is provided. To start the tool,
press in the lock-off button and pull the switch trigger.
Release the switch trigger to stop.
A hole is provided in the switch trigger for insertion of a
padlock to lock the tool off.
WARNING:
Do not use a lock with a shank or
cable any smaller than 6.35 mm (1/4") in diameter.
A smaller shank or cable may not properly lock the
tool in the off position and unintentional operation
may occur resulting in serious personal injury.
Electric brake
This tool is equipped with an electric blade brake. If the tool
consistently fails to quickly stop blade after switch trigger
release, have tool serviced at a Makita service center.
The blade brake system is not a substitute for blade guard.
NEVER USE TOOL WITHOUT A FUNCTIONING BLADE
GUARD. SERIOUS PERSONAL INJURY CAN RESULT.
ASSEMBLY
CAUTION:
• Always be sure that the tool is switched off and
unplugged before carrying out any work on the tool.
Hex wrench storage
► 1. Wrench holder 2. Hex wrench
The hex wrench is stored as shown in the figure. When
the hex wrench is needed it can be pulled out of the
wrench holder. After using the hex wrench it can be
stored by returning it to the wrench holder.
Installing or removing saw blade
CAUTION:
• Always be sure that the tool is switched off and
unplugged before installing or removing the
blade.
• Use only the Makita hex wrench provided to
install or remove the blade. Failure to do so may
result in overtightening or insufficient tightening
of the hex socket bolt. This could cause an
injury.
Lock the handle in the raised position by pushing in the
stopper pin.
1
► 1. Stopper pin
Removing the blade
To remove the blade, use the hex wrench to loosen the
hex socket bolt holding the center cover by turning it
counterclockwise. Raise the blade guard and center
cover.
► 1. Center cover 2. Hex wrench
Press the shaft lock to lock the spindle and use the hex
1
wrench to loosen the hex socket bolt clockwise. Then
remove the hex socket bolt, outer flange and blade.
2
1
2
► 1. Shaft lock 2. Hex wrench
9 ENGLISH
1
2