Troubleshooting - Vornado 533DC Manual Del Propietário

TROUBLESHOOTING

PROBLEM POSSIBLE CAUSE AND SOLUTION
The unit fails to power on.
Unit is not plugged in. Plug Power Cord into electrical outlet. Model 683DC Only - Ensure the AC power
cord is plugged into the power supply and ensure DC power cord is plugged into the circulator.
Ensure unit fan speed setting is selected.
Unit is damaged or in need of repair. Cease usage and unplug. Contact Consumer Service for assistance.
The outlet is worn or damaged. Try another outlet or contact a qualified electrician.
Airflow is weak or slow.
Unit set to a low speed setting. Adjust to a higher speed setting.
Airflow is blocked. Remove obstruction.
Adjust direction of airflow towards the user.
GFCI has tripped.
Under certain conditions, it is possible for a reset GFCI (Ground Fault Circuit Interrupter) outlet to trip
when the user is changing speeds on a Vornado circulator. In this event, change to an outlet that is not
connected to a GFCI device. It could also indicate a weak or defective GFCI outlet. Contact a qualified
electrician to check the GFCI outlet.
12 English
TABLE DES MATIÈRES
Instructions de Sécurité Importantes ............................................... 14
Caractéristiques ................................................................................ 19
Assemblage Et Réglage Du Support ................................................ 20
Pour Démarrer .................................................................................. 21
Nettoyage ......................................................................................... 23
Dépannage ....................................................................................... 25
13
Français