De-Commissioning And Demolition - modbar espresso system Manual

1) De-commissioning and demolition

Start by setting the main switch to the "0"
or OFF position.
Disconnecting from the power outlet
Disconnect the machine from the electrical
network by switching off the associated
circuit breaker or circuit protection device.
Remove the power supply cord from the
power connection. Remove the Pump Motor
Power Cord from the water pump motor.
Disconnecting from the water system
Shut off the water supply by closing the
specific tap located upstream of the water
filter/softener inlet. Disconnect the water
pipe at the water filter/softener inlet.
Remove the hose connecting the espresso
machine to the water pump.
the reinforced plastic tubing on the drain
connection.
At this point, the machine may be removed
from the bar, being very careful not to drop
it or squash your fingers.
The machine is made out of various
materials and therefore, if you do not
intend to put it back in service, it must
be taken to a special disposal company
which will select the materials which can
be recycled and discard the others.
Current regulations make it illegal to
discard such machine by leaving it on
public grounds or on any private property.
6. De-commissioning and Demolition
Remove Recycling notice: Warning for the protection of the
environment:
Used Electrical and electronic waste con-
tains hazardous but also valuable and scarce
materials which should be recovered and
recycled properly. We kindly ask that you
contribute to the protection of the environ-
ment and natural resources by delivering
used equipment to the relevant recycling
locations if such locations are available in
your country.
17