Assembly Guide - NuWave Brio 14Q Manual Del Propietário

Ocultar thumbs Ver también para Brio 14Q:
Tabla de contenido
Idiomas disponibles

Idiomas disponibles

ASSEMBLY GUIDE

Rotisserie Skewer Assembly
To assemble the Rotisserie Skewer with poultry and other meats,
follow the steps below:
1.
Screw one Rotisserie Skewer fork
onto the end of the Skewer with the
rectangular end.
2.
Push the Skewer through the center of
the meat until the Skewer pierces the
food all the way through and out the
other side.
3.
Place the second Rotisserie Skewer
fork onto the other end of the Skewer
and push the fork forward until it
pierces the end of the meat. Tighten the
screw of the fork. If necessary, loosen
screw and move the first fork forward
until it pierces the other end of the meat
then retighten. Make sure both screws
are tight and in place.
4.
Place the rectangular end of assembled
Rotisserie Skewer into the Shaft Support
Hole. Insert other end of Rotisserie
Skewer into the Shaft Bracket.
Notes:
• For better results use kitchen twine around chicken or other meats.
• Always check that there is sufficient space above and below food
so it can rotate freely without obstruction.
• When using Rotisserie Skewer, place Drip Tray on the bottom.
Rotisserie Skewer parts will be hot during and after use.
10
10
assembly guide
CAUTION
Use oven mitts.
Rotisserie Basket Assembly
To assemble the Rotisserie Basket into the Brio, follow the steps and
illustrations below:
1.
Remove top lid from Rotisserie
Basket: Squeeze prongs on outside
of top lid toward middle and lift up.
Remove other end from holes.
2.
Place food in Basket.
3.
Adjust top lid to fit over food: Place
ends of top lid into slots above where
top of food ends. Squeeze prongs
on outside of top lid and slide down
into position and place prongs into
correct position.
• Position of prongs should be lined
up and opposite of slot holes on
other side.
• Make sure top lid lies flat on food
and fit is snug.
4.
After food has been inserted in
Basket and top lid has been adjusted,
place rectangular end of assembled
Rotisserie Basket into the Shaft
Support Hole. Insert other end of
Rotisserie Basket (skewer) into the
Shaft Bracket.
Notes:
• Always check that there is sufficient space above and below food
so it can rotate freely without obstruction.
• When using Rotisserie Basket, place Drip Tray on the bottom.
CAUTION
Rotisserie Basket parts will be hot during and after use.
Use oven mitts.
4
3
2
1
4
3
2
1
900
1500
1800
11
11
nuwavenow.com
nuwavenow.com
Tabla de contenido
loading

Tabla de contenido