Tabla de contenido
Idiomas disponibles
Idiomas disponibles
3. Move the lower dash cover (B) to release the cover
tabs (C) from the tapered slots (D) in the lower dash
cover (B) and then remove.
4. Remove the oil fill cap and dipstick.
CAUTION:
enter the engine when you change the
oil.
5. Install the drain tube (E) onto the oil drain valve.
F
6. Turn the valve counterclockwise with a 10 mm
wrench to open the oil drain valve (F).
7. Turn the drain valve clockwise to close it (G) when
the oil is drained.
Note:
Use a 10 mm wrench to apply a small
quantity of torque to keep the drain valve closed. Do
not tighten too firmly.
8. Remove the drain tube (E) and keep it.
9. Fill the engine with new oil through the oil fill dipstick
tube.
Note:
Put oil into the engine slowly. Do not fill
the engine with too much oil. For the approximate
Technical data on page 35 .
capacity, see
10. Use the gauge on the oil fill dipstick to do a check of
the oil level.
a) Put the dipstick into the tube and let the oil fill
cap touch the top of the tube.
b) Do not tighten the cap onto the tube when you do
an oil level check.
c) Make sure the oil is at the "FULL" line on the
dipstick.
d) Tighten the cap onto the tube tightly when you
complete the check.
To replace the engine oil filter
WARNING:
you spill engine oil on your body, clean with
soap and water.
1932 - 004 - 13.10.2022
Be careful not to let dirt
G
E
Use protective gloves. If
1. Drain the engine oil from the oil tank. Refer to
change the engine oil on page 26 .
2. Turn the engine oil filter counterclockwise to remove
it.
3. Lightly lubricate the rubber seal on the new oil filter
with new engine oil.
4. To install the new oil filter, turn it clockwise until
the rubber seal fits correctly, then tighten a half turn
more.
5. Fill the oil tank with new engine oil. Refer to
change the engine oil on page 26 .
6. Start the engine and let it operate at idle speed for 3
minutes.
7. Stop the engine and make sure that there is no oil
leakage from the oil filter.
Note:
If the there is oil leakage, tighten the oil filter
again.
8. Fill the oil tank with more engine oil to replace the
engine oil that the new oil filter has absorbed.
To clean the air filter
The engine will not run satisfactorily with a dirty air filter.
Clean the air filter more frequently in dusty conditions.
To clean the air screen
Note:
The air screen must be kept free of dirt to
prevent engine damage caused by overheating.
•
Clean the air screen with a wire brush or
compressed air to remove dirt.
To do maintenance on the engine cooling
system
Note:
A blocked grass screen, dirty or full cooling fins,
and/or removed blower housing, and so on, can make
the engine too hot and cause engine damage.
•
Make sure that the grass screen, the cooling fins,
and other external surfaces of the engine are clean
at all times.
•
After each interval of 100 hours of operation (more
often in extremely dusty and dirty conditions),
remove the blower housing and other parts of the
engine cooling system. Clean the cooling fins and
external surfaces as necessary. Make sure that the
engine cooling system parts are installed correctly.
To do maintenance on the muffler
Corrosion on the muffler and spark arrester can cause
fire and/or damage.
•
Examine the muffler and spark arrester (if the
product has one) and replace if necessary.
To
To
27
Tabla de contenido
Solución de problemas
