Tabla de contenido
Idiomas disponibles
Idiomas disponibles
•
Before you clean with water, clean with a brush.
Remove grass cuttings and dirt on and around the
transaxle fan and cooling fins.
•
Examine the cooling fan to make sure the fan blades
are clean and not damaged.
To examine the transaxle pump fluid
•
Make sure that the transaxle pump fluid does not
leak.
•
Speak to the nearest approved service center or
department if the transaxle pump fluid leaks.
To adjust the front wheel toe-in and camber
The front wheel toe-in and camber is correctly set at
the factory. The front wheel toe-in and camber are not
adjustable.
•
Speak to an approved service center if the factory-
set front wheel toe-in or camber is damaged.
To replace the fuse
This product has an automotive-type fuse. The fuse
holder is located behind the dashboard.
1. Hold the fuse holder and pull the blown fuse out.
2. Put a new fuse in the fuse holder.
To remove and install the engine cover and
the grill assembly
1. Lift the engine cover.
2. Disconnect the headlight wire connector (A).
3. Stay in front of the tractor. Hold the engine cover on
its sides. Tilt the engine cover in the direction of the
engine and lift it to remove it from the product.
4. Install in the opposite sequence.
1932 - 004 - 13.10.2022
A
To replace the motion drive belt
B
A
C
D
E
F
Park the product on a level surface. Engage the parking
brake. Refer to the belt installation decal on the bottom
side of the left footrest.
1. Remove the belt.
a) Remove the mower. See
the cutting deck on page 23 .
Note:
Be careful with the motion drive belt and
the position of the belt guides and keepers.
b) Disconnect the clutch wire harness (A).
c) Remove the anti-rotation link (B) on the right side
of the product.
d) Remove the belt from the stationary idler (C) and
clutching idler (D).
e) Remove the belt from the centerspan idler (E).
f) Pull the belt to the rear part of the product.
Carefully remove the belt from the transmission
input pulley and above the cooling fan blades (F).
g) Remove the belt from the engine pulley and
around the electrical clutch (G).
h) Move the belt to the rear part of the product
and off the steering plate (H). Remove from the
product.
2. Install the new belt from the rear part of the product
to the front, and above the steering plate (H) and
clutch brake pedal shaft (I).
a) Pull the belt to the front of the product and install
the belt around the electrical clutch and onto
engine pulley (G).
b) Pull the belt to the rear part of the product.
G
H
I
To remove and install
21
Tabla de contenido
Solución de problemas
