D-Fi Usb Connectivity - Chauvet DJ COREparQ120 ILS Guía De Referencia Rápida

IRC-6
The COREpar Q120 ILS can be operated with the CHAUVET Infrared Remote Control (IRC-6). For more information
about the IRC-6, download instructions for the IRC-6 or the COREpar Q120 ILS User Manual from www.chauvetdj.com.
Button
<BLACKOUT> Turns LEDs on/off
<AUTO>
BLACK
<SOUND>
AUTO SOUND
OUT
<SPEED>
SENSI-
STROBE SPEED
TIVITY
<SENSITIVITY> Adjusts sound sensitivity
%
MANUAL FADE
<FADE>
R G B
<STROBE>
A UV W
<%>
-
+
0
<R,G,B,W>
1 2 3
4 5 6
<0>–<9>
7 8 9
<+>
<->

D-Fi USB Connectivity

The COREpar Q120 ILS is able to become a D-Fi wireless receiver/transmitter with the use of the D-Fi USB from
CHAUVET DJ. Simply set the DIP switch D-Fi receiving/transmitting channel, plug it into the USB port then set the
product's DMX Personality and DMX Address.
WARNING! DO NOT plug anything other than a D-Fi USB into the USB port. Doing so may cause
damage to the product.
Once plugged in, the D-Fi USB will take over the product. Wired DMX and manual display control/menu
buttons will be unavailable until you unplug the D-Fi USB. The priority levels are:
1. D-Fi USB
2. Wired DMX
3. IRC-6 Remote Control
4. Manual Digital Display/Menu Buttons
Master/Slave Mode (D-Fi USB)
The D-Fi USB allows a single COREpar Q120 ILS product (the "master") to control the actions of one or more
COREpar Q120 ILS products (the "slaves") without the need of a DMX controller or DMX cables. The master (transmitter)
product will be set to operate in standalone mode, while the slave (receiver) products will be set to operate in DMX mode.
Once set and connected, the slave products will operate in unison with the master product.
Configure the products as indicated below.
Slave products:
1. Press <MENU> repeatedly until 9-Ch shows on the display.
2. Press <ENTER>.
3. Use <UP> or <DOWN> to set the starting address to d 1.
4. Press <ENTER>.
5. Set the D-Fi USB to receive on a specific channel, 1–16.
6. Plug in the D-Fi USB.
7. Finish setting and connecting all the slave products.
Master product:
1. Set the master product to operate in standalone mode.
2. Set the D-Fi USB to transmit on the D-Fi channel the slaves are receiving on.
3. Plug in the D-Fi USB.
• All products must be set to the same DMX personality, DMX address, and D-Fi channel.
• Configure all the slave products before configuring the master to transmit.
• Never connect a DMX controller to a D-Fi channel configured for Master/Slave operation
because the controller may interfere with the signals from the master.
COREpar Q120 ILS QRG Rev. 5
QUICK REFERENCE GUIDE
Function
Enables snap and fade modes
Enables sound active mode
Increases and decreases speed
Fade program
Adjusts strobe speed
Adjusts brightness
Adjust percentage of red, green, blue, and white colors
1:C1 2:C20
6:C3 7:C23
Increases values for controls as described above
Decreases values for controls as described above
3:C5 4:C2
8:C6 9:C11
5:C8
0:C4
EN
4