Skil PWRCORE 20 Manual Del Propietário página 13

LED Light (Fig . 5)
Your tool is equipped with an LED light, located
on the head of the tool. This provides additional
light without shadows on the surface of the
work piece for operation in lower-light areas.
To turn on the LED light:
The LED light will automatically turn on with a
•
slight squeeze on the variable-speed trigger
switch before the tool starts running.
The LED light could be turned on manually
•
by pressing the LED light button.
To turn off the LED light:
The LED light could be turned off manually
•
by pressing the LED light button after the
variable speed trigger switch is released.
The LED light will turn off approximately 10 seconds after the variable speed trigger switch is
•
released without pressing the LED light button.
The LED light will turn off approximately 10 minutes after turning on the LED light by
•
pressing the LED light button without squeezing on the variable-speed trigger switch.
NOTICE: The LED light button is disabled when the motor is running.
When the tool and/or battery pack becomes overloaded or too hot, the internal sensors will
turn the tool off. If the tool and/or battery pack are overloaded, the LED light will flash rapidly.
Rest the tool for a while or place the tool and battery pack separately under air flow to cool.
The LED light will flash more slowly to indicate that the battery is at low-battery capacity.
Recharge the battery pack.
Changing the Work Modes
When the tool is set in reverse rotation, the
work mode – a combination of rotation speed,
impact rate, and torque – can be changed to
allow a loosening force suitable to the work at
hand. Every time the mode button is pressed,
the mode will toggle between 4 work modes:
a. Low-Speed Mode - Indicator light above "1"
shines green.
b. Medium-Speed Mode - Indicator lights above
"1" and "2" shine green.
c. High-Speed Mode - Indicator lights above 1,
2, and 3 shine green.
d. Reverse Control Mode - Indicator light
corresponding to "RM" shines green.
In reverse control mode, the tool loosens a bolt or nut at high-speed first. Once the nut or bolt
is completely loose, the tool will stop automatically to prevent the bolt or nut from falling out.
The reverse control mode is available only when the tool is set is reverse rotation. If the tool is
switched to forward rotation while in reverse control mode, the impact force and speed are the
same as the high-speed mode "3".
Fig . 5
LED Light
Variable-Speed
Trigger Switch
LED Light Button
Mode Button
Fig . 6
1 2 3 RM
M
10 MINS
ON
OFF
1 2 3 RM
M
10 MINS ON
OFF
1 2 3 RM
M
10 MINS
ON
OFF
1 2 3 RM
M
10 MINS
ON
OFF
Low-Speed Mode
Medium-Speed
Mode
High-Speed
Mode
Reverse Control
Mode
13