Glowforge Pro Guia Del Usuario página 54

Insert the Rear Foam Block
With the lid removed, insert the foam block
containing the printer head and power cord
into your Glowforge. The bottom will lay flat
against the floor of your unit.
Screw in Red Knobs
Locate the holes near the center of each rail.
On both sides, screw the red knob through the
hole in the laser arm to secure the laser arm to
the rail. They must be screwed in as tight as
your fingers will permit, but do not use a tool
to tighten them.
Insert the Rear Foam Lid and Front
Foam Block
Place the lid of the rear foam block, covering
the printer head and power cord. Place the
final foam block in the front of your unit and
close the front door.
54
Copyright Glowforge, Inc. 2019