Power Off - Glowforge Pro Guia Del Usuario

Remove the back Pro Shield from the inner back wall of your Glowforge
Turn the black finger screws on either end of the Pro Shield counterclockwise to unscrew
them, then lift the shield away from the wall.
Reinstall your crumb tray, close the front door, and turn on your Glowforge!
Instructions for ​ i nstalling your crumb tray​
Cleaning, Service & Moving
Power Off
Always turn your Glowforge off before cleaning
Floor and crumb tray
Remove leftover cutting and engraving bits from the floor and the crumb tray whenever there is a
buildup. Bits on the tray can prop your material up in the air, and a buildup of cutting and engraving
bits can create a fire hazard.
To remove the crumb tray, lift the lid, then swing down the front door. Lift the crumb tray slightly
and slide it towards you. Be careful not to tilt the crumb tray up, or it will knock into the printer
head and rails.
Tilt the tray handle side down over a trash bin and empty out all the tiny remains of past projects
that have fallen through the metal grid. If necessary, turn the tray upside down and shake out
anything that's left. Use cotton swabs to gently remove bits that get caught. Be careful not to
bend the grid.
Wipe the metal floor of the Glowforge unit with a soft cloth to sweep away any bits.
Copyright Glowforge, Inc. 2019
are available.
39