Interrupting A Programme; Cancelling A Running Programme; Opening The Door - AEG L 82470 BI Manual De Instrucciones

16 www.aeg.com
press button Inicio/Pausa to pause the
appliance.
Changing a running programme is
possible only by resetting it.
Turn the programme dial to Off and then
to the new programme position.
Press Inicio/Pausa button again to start
the new programme. The washing water
in the tub will not emptied out.
10.8 Interrupting a
programme
Press button Inicio/Pausa to interrupt a
programme which is running, the
corresponding indicator starts blinking.
Press button Inicio/Pausa again to restart
the programme.
10.9 Cancelling a running
programme
Turn the selector dial to Off to cancel a
programme which is running. Now you
can select a new programme.
Before starting the new
programme the appliance
could drain the water. In this
case, make sure that the
detergent is still in the
detergent compartment, if
not fill the detergent again.

10.10 Opening the door

When the appliance is working and
through the delay time, the door is
locked.
Press firstly button Inicio/Pausa to set the
machine to pause:
• If the indicator
few minutes goes off, the door can be
opened.
• If the indicator
door remains locked, this means that
the appliance is already heating or
that the water level is too high. In this
case the door cannot be opened.
If, for any reason, it is necessary to open
the door, turn the programme dial to Off
to switch the appliance off. After a few
minutes the door can be opened (pay
disappears, after a
stays on and the
attention to the water level and
temperature !) .
After closing the door, it is necessary to
set the programme and the options
again. Press button Inicio/Pausa to start
the programme again.
10.11 At the end of the
programme
The appliance stops automatically. The
indicator of button Inicio/Pausa goes off.
A blinking will appear on the display.
Some acoustic signals sound.
The indicator disappears from the
display.
If you have set a programme or an
option that ends with water in the tub,
the indicator remains on and the
door locked. The water must be emptied
out before opening the door. During this
time the drum continues to turn at
regular intervals until water drain.
Follow the below instructions to empty
out the water:
• Turn the programme selector dial to
Off.
• Set the DRAIN or SPIN programme.
• Reduce the spin speed, if needed.
• Press button Inicio/Pausa.
• When the programme has finished
the display shows a blinking
indicator goes off. The door can
be opened.
Turn the programme selector dial to Off
to switch the appliance off.
Remove the laundry from the drum and
carefully check that the drum is empty. If
you do not intend to carry out another
wash, close the water tap. Leave the
door open to prevent the formation of
mildew and unpleasant smells.
10.12 Stand by
Once the programme has finished, after
few minutes the energy saving system
will be enable. The brightness of the
display is reduced. By pressing any
button the appliance comes out from the
energy saving status.
. The