Assembling Brake - Manutan A369872 Manual Del Usuario

The fork descends without
5
the release valve worked
Note: Do not attempt to repair the pallet truck unless you are trained or authorized to do so.
7.1 Inspection
The hand pallet truck must be inspected by authorized person minimum one time per year.
The result of checking must be filled in the report.
VBG 36, § 37
7.2 Disposa
l
After using, the pallet truck should be disposed corresponding to the law regulations.
All parts should be brought for recycling.

8. ASSEMBLING BRAKE

1. Unscrew the screw pin of the brake
2. Use a hammer and pin driver to remove spring pin at the steering wheel (part No. 23)
3. Remove the wheels (Part No. 26) and the steering wheel axis (Part No. 21)out of the hand pallet
truck
4. Lift the whole hand pallet truck up and assemble the brake into the pump body (Part No. 15)
5. Let the steering wheel axis (Part No.21) go through the hole of the pump body (Part No. 15) and
the hole of the brake
6. Screw in the screw pin of the brake to make sure that the beak and the steering wheel axis (Part
No. 21) are totally connected to the pump axis.
7. Assemble the two steering wheels (Part No. 26) back into the wheel shaft
8. Use hammer to place the spring pin (Part No. 23) into the holes.
9. Screw in or out the screw pin to have a good distance between the wheels and the brake.
10. Press "LOCK" to brake a hand pallet truck. Press "MOVE" before using or moving hand pallet truck
- The impurities in the oil cause
the release valve to be unable to
close tight.
- Some parts of the hydraulic
system is cracked or bored.
- The air comes into the hydraulic
oil.
- Sealing parts worn or damaged.
- The adjusting nut (Part No.59) is
not the the correct position.
9
- Replace with the new oil.
- Inspect and replace the
waste parts.
- Bannish the air (See item 5.2)
- Replace with the new one.
- Adjust the nut (Part No.59)
(see the item 3.3)