Service And Guarantee; Guide To Safety Operation - Manutan A369872 Manual Del Usuario

4.2 How to take the load
Drive the truck slowly in front of the pallet. Then, drive the fork of the truck under the pallet up to
end of the fork length. (Pict 3.A).
Lift the load by pumping the handle at Raise position.The load must be on the
center of the hand pallet truck. Otherwise, the hand pallet truck can be overturned
4.3 Drive with load
It is not necessary to pump the pallet truck to the highest position to drive. You must pay attention
to the space between the bottom of the pallet and always keep the pallet clear of the floor. You
should carefully drive the hand pallet truck at a stable speed paying due care and attention to the
environment around you.
4.4 Lowering the Load
Lift the Lever to the Lower position, ensuring a free space behind. Then the truck can be pulled out
of the pallet.
4.5 How to use the hand pallet truck on the truck
Only move the pallet truck slowly, at all times be careful that the hand pallet truck can not fall down
from the truck or the user will not be in the middle between the hand pallet truck and other loads. If
the pallet truck is not used, it must be firmly fixed on the truck when the truck is moving.

5. SERVICE AND GUARANTEE

5.1 Oil
The best working condition for the Hydraulic oil in the pallet truck is -6°C to 45°C only. If the pallet
truck is used in a temperature under -6°C , operator should pay attention to fuctions of hand pallet
truck and should consider to use other Hydraulic oil with lower vicostity.
Please check the oil lever every six months. The hydraulic oil volume in the pump is 300 ml.
Used oil must be disposed off according to the latest regulations.
5.2 To remove the air
The air may come into the hydraulic oil because of transportation or pump in upside
down
position. It can cause that the forks do not elevate while pumping the RAISE position. The air can
be removed in the following way: Let the Lever (Part No. 51) on the LOWER position, then move the
Handle up and down several times.
5.3 Daily check and Maintenance
Daily check of the pallet truck can limit wear as much as possible. Special attention should be paid
to the wheels, the axles, as thread, rags, etc. It may block the wheels. The forks should be unloaded
and lowered in the lowest position when the job is over.
5.4 Lubrication
All bearings and shafts are provided with long-life grease at the factory. You only need provide long-
life grease at monthly intervals or after each time the truck is cleaned thoroughly to the lubrication
points.
5.5 Guarantee
This hand pallet truck is guaranteed within 24 months for private users and 12 months for company
users after the date of buying. The guarantee is only given if the hand pallet truck is used and serviced
as instructed in this Manual. There is no guarantee for consumable parts.

6. GUIDE TO SAFETY OPERATION

6.1 Operator should read all warning signs and instruction here and on the pallet truck before using
this truck
6.2 Do not operate a hand pallet truck unless you are familiar with it and have been trained or autho-
rized to do so
6.3 Do not operate a hand pallet truck unless you have checked its condition. Give special attention
to the wheels (part No. 26, Part No. 71), the Handle unit, the fork unit, the cam (Part No. 17), etc.
7