Handle Assembling - Manutan A369872 Manual Del Usuario

2. HANDLE ASSEMBLING

2.1 Pull down the lever to the Lifting position. (lifting )
2.2 Insert the handle onto the pump piston (Part No. 1), then use a hammer to insert the axle with
hole ( Part No. 46) into the hydraulic pump and handle from the right to the left. (See Pict 1).
Pass the adjusting nut (Part No. 59), adjusting bolt (Part No.58) and chain (Part No. 60) assembly
through the hole of axle (Part No. 46) with your hand
2.3 Use the hammer to tap another spring pin (Part No. 23) into the axle with the hole (Part No. 46).
Using a 3mm Punch to finish
2.4 Using screw driver to lift up the Cam (17) and put the adjusting nut into the Cam slot, check the
correct position of the chain. (see Pitc 2, 1).
2.5 Remove the Pump locker (Pict 1,Nr.3)
2.6 Now the Handle is already assembled to the Hand Pallet Truck.
4