Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Tools and Parts
Parts supplied
Removing the packaging
I
CAUTION!
Remove carton carefully, wear gloves to protect against sharp
edges.
I
WARNING!
Remove the protective film covering the product before putting
into operation.
• Hood assembly with blower and LED lamps already installed.
• Hardware bag with:
Part
Hood assembly
Rectangular duct 31⁄
" x 10" (8.3 x 25.4 cm)
4
4.5x13 mm
3.5x6.5 mm
Parts not supplied
Tools/Materials required
• Drill
• 11⁄
" (3.0 cm) drill bit
4
•
⁄
" (3.0 mm) drill bit for pilot holes
1
8
• Pencil
• Wire stripper or utility knife
• Tape measure or ruler
• Caulking gun and weatherproof caulking compound
• Saber or keyhole saw
• Metal snips
• Screwdrivers:
Phillips
Flat-blade
Parts needed
• Home power supply cable
• ½" (12.7 mm) UL listed or CSA approved strain relief
• 3 UL listed wire connectors
For vented installations, you will also need:
• 1 wall or roof cap
• Metal vent system
Optional Accessories
KIT
Recirculating Kit
7" Round Kit
Upgrade
Filters Kit
Dimensions and
Clearances
Qty
1
D
1
4
1
A
B
C
D
E
F
Electrical Requirements
IMPORTANT
Observe all governing codes and ordinances.
It is the customer's responsibility:
• To contact a qualified electrical installer.
• To assure that the electrical installation is adequate and
inconformance with National Electrical Code, ANSI/
NFPA 70— latest edition*, or CSA Standards C22.1-94,
CanadianElectrical Code, Part 1 and C22.2 No.0-M91 - latest
edition** and all local codes and ordinances.
• If codes permit and a separate ground wire is used, it is
recommended that a qualified electrician determine that the
ground path is adequate.
• Do not ground to a gas pipe.
3
# Part
30" (76.2 cm)
36" (91.4 cm)
KIT02178
KIT02723
KIT02591
F
E
A
B
Models
AUR330SSA
AUR336SSA
30" (76.2 cm)
36" (91.4 cm)
20" (50.8 cm)
4
⁄
" (12 cm)
7
10
2
⁄
" (5.7 cm)
2
5
3
⁄
" x 10" (8.3 x 25.4 cm)
1
4
51⁄
" (13 cm)
10
KIT02179
KIT02592
C
Tabla de contenido
