EdilKamin CALGARY Instalación Uso Y Mantenimiento página 43

POSSIBLE TROUBLESHOOTING
Problem: Turns off for lack of depression
10) Signalling: check_a/entrace:
being activated.
11) Signalling: STOP T/ SCREW 1:
Problem:
12) Signalling: STOP G/SCREW 1: (intervenes when the gear motor 1 is blocked or malfunctioning)
Problem: Check the wiring of the gear motor 1 or else replace it.
13) Signalling: STOP G/SCREW 2: (intervenes when the gear motor 2 is blocked or malfunctioning)
Problem:
Check the wiring of the gear motor 2 or else replace it
14) Signalling: "Battery check"
Problem: The boiler does not stop but the error appears on the display.
Actions:
15) Signalling: WARMING LOADER 2
Problem: The sensor connected to auger 2 has detected a temperature which is superior to the threshold of the
"LOAD 2 °C max" parameter.
Actions:
The backup battery on the board must be replaced.
16) Signalling: No link/NTC CO.2
Problem: Auger temperature sensor 2 malfunctioning or disconnected.
17) Signalling: Check button: Intervenes when there is a connection problem between the synoptic panel and the boiler
Actions:
18) Signalling: HIGH CURR. ALARM: Intervenes when a problem or excessive current absorption by the feed screw gear
motor 1 is detected.
Actions:
19) Signalling: LOW CURR. ALARM:
motor 1 is detected.
Actions: Probable gear motor triac control fault/wiring connection error, gear motor fault.
20) Problem: The pellet DOES NOT enter the crucible:
reset.
21) Problem: synoptic panel is off:
Actions:
22) Problem: Water is not hot enough:
Actions:
NOTA
All signals/warnings remain shown until you intervene on the remote control, by pressing the button 0/1.
Do not use the boiler before having eliminated the problem.
It is important to tell the Dealer exactly what the panel signals.
- 43
-