Acetech iTracer Unit Manual De Instrucciones página 33

Function Setting
Total Shot
Show the cumulative
total number of shots.
Set Value:0~99999999
iTracer Unit Bind
Bind iTracer Unit and
iTracer CD
Set Value:BINDING
Already finished
binding after leaving
factory
SCU Bind
Bind iTracer SCU and
iTracer CD
Set Value:BINDING
Already finished
binding after leaving
factory
1.Press data knob
enter the interface of
" Total Shot "function.
To check the cumula- (Figure-27)
tive value
2.Press and hold
data knob for 10 seco-
nds to reset the cumulative
value.
1.Press data knob
"iTracer Unit Bind" function and the word
"BINDING"will flicker on OLED.
2. After turning on iTracer Unit, please make sure
that the power indicator blinks normally.
Then, press and hold the power button of iTracer
Unit to start binding process until the OLED of
iTracer CD shows "OK"(to notify you that the
binding process is successful .)
(For more detailed introduction, please read P.19)
1.Press data knob
"SCU Bind" function. Then, OLED will show the
flickering word "BINDING" .
2.Connect SCU to AEG battery and then press the
button on SCU to start binding process.
3.OLED will show "OK" when finishing binding is
completed.
(For more detailed introduction, please read P.20)
Introduction
:
Total Shot
Figure-27
(
to enter the interface of
to enter the interface of
)
EN
32
EN