Acetech iTracer Unit Manual De Instrucciones página 29

Function Setting
Low Ammo Alert
Set Value:
OFF or 1~99
Default:99
Stop as Zero
Set Value:YES or NO
Default:YES
Note :
If you press the trigger
after BBs already
decreased down to zero
under the "Count Down"
mode, SCU will alert you
by driving the motor to
beep 3 times.
Turn on/off the "Low Ammo Alert" function.
If you turn on this function, you can set the value
of"Low Ammo Alert"(Rotate data knob to adjust
the value and then press it to enter and confirm the
value you set.) .
Then, under "DN mode"(Count Down mode), you
will be alerted by showing the "low - ammunition"
icon on screen when the number of BBs equals to or
is fewer than the value you set previously.
(Please see remarks on P.6 to get more info.)
1.Press data knob
enter the interface of
"
Low Ammo Alert
function.
(Figure-7)
2.Rotate data knob
clockwise/counterclockwise:
To turn ON/OFF
"Low Ammo Alert" function
and adjust the value (1~~99)of it.
3.Press data knob
Screen flickers and then the setting is completed.
(
If you turn on "Stop as Zero" function, when the num-
ber of BBs decreases down to zero under the
"Count Down" mode, SCU will disable the trigger so
that you could not fire temporarily. You have to press
and hold the "Data Knob" for a while to reload the initial
value then the function of the trigger will be resumed
by SCU.
1.Press data knob
enter the interface of
" Stop as Zero " function.
(Figure-9)
2.Rotate data knob
clockwise/counterclockwise:
To turn ON / OFF"Stop as Zero"funtion.
3.Press data knob
(Screen flickers and then the setting is completed.
Introduction
to
Low Ammo Alert
"
(
(
(Figure-8)
:Confirm.
Stop as Zero
to
(
Figure-10
(
:Confirm.
Figure-7
)
20
Figure-8
)
)
Figure-9
)
YES
)
(Figure-10)
)
28
EN
EN