Count Down - Acetech iTracer Unit Manual De Instrucciones

2-1-2 Instruction for Each Mode
● UP mode:
Count up function. The number of cumulative BB
firings will be shown on the screen.When the
mode is switched to UP mode, the screen will
show "Count Up" for 1 second and then enter the
interface of Count Up mode.
* Press and hold data knob
reset the values of Count Up.
● DN mode:
Count down function. The number of decreasing
BB firings will be shown on the screen.
When the mode is switched to DN mode, the scr-
een will show "Count Down" for 1 second, and
then enter the interface of Count Down function.
* Press and hold data knob
reset the values of Count Down.
Remarks :
Under "DN mode",you can press and hold the
data knob for a while to load the value you set
in the "Count"of "ST" mode(setup mode).
Once you fire a BB, the initial number shown
on screen under Count Down mode will be
decreased by 1, and so on. If the number is lower
than the value you set in "Low Ammo Alert"
function (under Setup mode), the screen will show a low-ammunition
icon to alert you that there are just few BBs in your magazine now.
When the current count reaches 0, SCU will disable the trigger of AEG
and you could not fire at this moment.
(This function can only be used with AEG. To activate this function,
iTracer SCU must be installed in AEG in advance and the function of
"Stop as Zero" should be turned ON.)
0
for 2 seconds to
for 2 seconds to
Show the status of voltage of AEG battery.
- / -
(The SCU must be installed in AEG in advance.)
AUTO
Show the status of Multiple-Round Burst /AUTO.
Count Up
0
- / -
AUTO

Count Down

300
- / -
AUTO
(low-ammunition icon)
EN
23
EN