Power Saving - Acetech iTracer Unit Manual De Instrucciones

Function Setting
Display

Power Saving

iTracer CD Power Saving
mode.
Set Value:ON or OFF
Default:ON
AEG
Battery Protect
When you turn on
"AEG Battery Protect"
function and if the volt
of AEG battery is lower
than the value you set,
OLED will show alerting
icon and SCU will disable
the trigger so that you
could not fire tempora-
rily.
Set Value:OFF or 5~9V
Default:OFF
When iTracer CD is idle for more than 10 seconds,
OLED brightness will be turned to the lowest.
When you operate any function of iTracer CD or fire your
Airsoft gun, the OLED will turn to the normal brightness.
1.Press data knob
enter the interface of
" Display Power Saving "
function.
(Figure-23)
2.Rotate data knob
clockwise/counterclockwise:
To turn ON / OFF
"Display Power Saving"function.
3.Press data knob
Screen flickers and then the setting is completed
(
1.Press data knob
enter the interface of
" AEG Battery Protect "
function.
(Figure-25)
2.Rotate data knob
clockwise/counterclockwise:
To turn ON/OFF "AEG
Battery Protect"function
and adjust the value of it.
3.Press data knob
Screen flickers and then the setting is completed
(
Li-poly battery is the mainstream at present. We
recommend two setting values for different volts
of Li-poly battery:
7.4V AEG Battery > The recommended value of Battery
11.1V AEG Battery >The recommended value of Battery
Introduction
Display
to
Power Saving
Figure-23
(
Figure-24
(
(Figure-24)
: Confirm.
to
AEG Battery
Protect
Figure-25
(
Figure-26
(
(Figure-26)
:Confirm.
Protect setting is 5V
Protect setting is 8V
)
EN
ON
)
.)
)
5.0V
)
.)
31
EN