Automatic Cleaning - Taurus 997150A Manual De Instrucciones

select small ice cubes to avoid the ice sticking
together.
3.2.6. The ice making cycle lasts approximately 6 to
13 minutes, depending on the selection of ice cube
size and the room temperature. The recommended
room temperature is 10°C to 40°C.
3.2.7. If the water pump cannot inject water, the ice
maker will stop automatically, and the "ADD WATER"
indicator will be on.
3.2.8. When the "ADD WATER" indicator turns on,
Press the "ON/OFF" button. Open the lid and fill the
water tank to the max mark with water. Then press the
"ON/OFF" button again to turn on the machine. Allow
the refrigerant liquid inside the compressor at least 3
minutes to settle before restarting.
3.2.9. The ice maker stops when the ice basket is full
and the "ICE FULL" indicator will be on. Warning:
Direct sunlight or sunlight reflection may cause infrared
sensor malfunction. If the unit doesn't stop, then move
the unit where there's no sunlight.
3.2.10. Change water in the reservoir every 24hours
for hygiene purposes. If the unit isn't being used, drain
all the wate and dry the tank.

3.3. Automatic Cleaning

3.3.1. When the machine is in standby mode, press
the "CLEAN" button. You will then see 30 on the
display, which means 30 minutes for cleaning. After 30
minutes the machine will be on standby mode again.
3.3.2. If you want to stop the cleaning process, press
the "CLEAN" or the "ON/OFF" button. During the
cleaning, auxiliary tools, like neutral or food hygiene
cleaners, can be used.
3.4. Timer
3.4.1. Timing setting range: 1-24 hour. The default
timer is 1 hour.
3.4.2. Timed shutdown: the machine can be set to shut
down during the ice making process.
3.4.3. Timed start-up: When the machine is in standby
mode, a start time can be set.
3.4.4. How to set the timer.
3.4.4.1. Press the "TIMER" on the operation panel, it
will display 01H for the default timing, and the "H" will
be flashing. Then adjust the timing by pressing the "L"
for increasing 01H or "S" for decreasing, based on
your needs.
997150_IM.indd 4
3.4.4.2. After 5 seconds the "H" will stop flashing and
the light will turn on, this means the setting is complete.
3.4.4.3. The "xxH" in the display indicates that the
machine currently has a timing function. After the
countdown is at zero, the machine will enter the mode
you need.
3.4.5. How to cancel the timer.
3.4.5.1. If the machine is timed (xxH on the screen),
press "TIMER", and the "H" will flash on the screen,
press "TIMER" again. The timer will be cancelled. You
can also press the "ON/OFF" button for timing to cancel.
4. Recycling
4.1. These electrical products, cables, batteries,
packaging, and the manual, should not be mixed with
general household waste. For proper recycling, please
take these products to your nearest Creative
Housewares office where they will be accepted for
recycling free of charge.
4.2. Alternatively, please contact your local authority or
household waste disposal service for further details of
your nearest designated collection point. Correct product
disposal saves resources and prevents negative effects
on human health and the environment.
2018/01/15 11:14:02 AM