iM3 ART-SP6 Instrucciones De Uso página 21

5. Digital Display
The digital display shows the current operation mode (polishing or scaling mode) and the
power / micro-motor speed level.
6. Water control knob
The water control knob allows you to control the amount of water that flows through the hand
piece. If turned clockwise, the amount of water will decrease. If turned counter-clockwise,
the amount of water will increase. Please note that water is necessary to cool the tip and
prevent overheating so it is necessary to ensure that an adequate amount of water flows
through the hand piece while operating the device. The larger the water stream, the lower the
temperature, and vice versa.
WARNING：Do not turn the water knob counter-clockwise more than three full turns.
Doing so will damage the internal water line needle.
WARNING：If needed, gently adjust the water control knob to prevent any serious
damages to the water valve.
7. Water hose input connector
The water hose input connector is the contact point for the water tube and the main water
supply line. Use either a male or female quick connect to connect the water tube to the water
supply.
8. Footswitch Socket
The foot switch socket is where you connect the foot switch to the main unit. It is located
next to the water hose input on the back of the main unit.
9. Power cord socket
The power cord socket is where you connect the power cord to the main unit.
10. Power button (ON/OFF)
The power button is used to turn the ART-SP6 main unit on and off. When the power is on,
the LCD indicator should be lit. When turned off, the LCD power indicator should not be lit.
Do not press the foot switch while turning on the ART-SP6.
11. Forward / Reverse switch
The Forward/Reverse switch allows you to control the direction of the micro-motor. It is
located on the back of the main unit.
- 19 -