Starting The Generator; Electric Start - WARRIOR 6500SV Operating Manual

WPE DIESEL GENERATORS
Break-in operation
While your generator is still new, application of heavy
loads may shorten the life of the engine. Follow the break-
in procedures during the first 20 hours.
1. Avoid applying any heavy load during the break-in
period.
2. Change engine oil regularly. Change the engine oil
every 20 hours or one month after the initial use, and
every 3 months or 100 hours thereafter.
3. If using is hot weather or high loads change oil 100
hours or 1 month.

Starting the generator

Recoil start (Open Frame Type Only)
1. Open the fuel cock (at the "ON" position).
2. Put the engine speed lever in the "RUN" position.
3. Pull out the recoil starting handle.
4. Pull out the handle to the point where your hands
feel strong resistant and then return it to the initial
position.
5. Push down the decompression lever. (It will return
automatically when the recoil starter is pulled).
6. Pull out the recoil starting handle briskly with both
hands.
7. Do not allow the handle grip to snap back against
the engine. Return it gently to prevent damage to the
starter.
WARNING

NEVER pull out or touch the recoil when the diesel
engine is running, otherwise it will damage the
engine. (open frame type only)
8. In cold weather, when diesel engine is difficult to
start, remove the red plug from the rocker arm cover
and add 2 cc of engine oil.
9. Replace the red plug before starting.
10. Always keep the red plug in the cover except
when adding oil, otherwise rain , dirt and other
contaminants may enter the engine and cause
accelerated wear of internal engine parts. This in
turn can cause serious engine problems.

Electric Start

1. Turn ignition key clockwise to 'ON' position.
2. Put the engine speed lever in the "RUN" position.
3. Turn the ignition key clockwise to "Start" position.
4. Release your hand from the key as soon as the
engine starts and let the key return automatically to
initial 'ON' position.
5. For cold weather starting refer to Preheater feature
6. If the starter motor doesn't engage and turn over the
engine after 10 seconds, please wait for about 30
seconds before attempting to start again and repeat
this process. .

Please Note: NEVER hold the key in the start position for
more than 10 secs, release and try again if the engine does
not start first time otherwise damage can occur to starter
motor.
If the starting motor is run for too long it will flatten the
battery and the generator will not start (Canopy type)
Remote Control (If Applicable)
Generator can be started or stopped remotely using a
wireless transmitter
1. Ensure lever is in 'RUN' position
2. Leave ignition key in 'OFF' position (No Clockwise
Turn).
3. To start engine, press and hold button 'A' on
transmitter for approx. 3-5 seconds.
4. If generator does not start repeat 1-2 steps and retry.
5. To stop engine press 'B' button on transmitter.

In electric key start mode: After the generator is
stopped or not in use you MUST turn the ignition key
to the 'OFF' position otherwise battery will flatten
over time.

If Generator doesn't start after 3 attempts,
steps 1-3 need to be REPEATED as well as general
maintenance of oil level and fuel level need to be
checked.
Never allow anybody other than the owner or
user to remotely start or stop the generator using
the wireless transmitter. Constantly starting and
stopping the generator will damage electric/
electronic components or equipment and also will
cause increased engine wear.
If the generator doesn't not start at all after many
attempts there may be malfunction or fault and you
will need to contact your local service centre on
[email protected].
6
OPERATION
WARNING
WARNING
WARNING