Skil 2415 Instrucciones De Funcionamiento página 9

SM 1619X06384 06-11:SM 1619X06384 06-11.qxp 6/30/11 10:00 AM Page 9
VARIABLE SPEED CONTROLLED
TRIGGER SWITCH
Your tool is equipped with a variable speed
trigger switch. The tool speed can be
controlled from the minimum to the maximum nameplate RPM by the pressure you apply to
the trigger. Apply more pressure to increase
the speed and release pressure to decrease
speed. This accurate speed control enables
you to drill without center punching. It also
permits you to use as a power screwdriver.
Bits are available for driving screws as well as
running bolts and nuts.
FORWARD/REVERSING LEVER &
TRIGGER LOCK
After tool use, lock trigger in
WARNING
"OFF" position to help prevent
accidental starts and accidental discharge.
Your tool is equipped with a forward/
reversing lever and trigger lock located above
the trigger (Fig. 1). This lever was designed for
changing rotation of the bit, and for locking the
trigger in an "OFF" position.
For forward rotation, (with chuck pointed away
from you) move the lever to the far left.
For reverse rotation move the lever to the far
right. To activate trigger lock move lever to the
center off position.
Do not change direction of
CAUTION
rotation until the tool comes
to a complete stop. Shifting during rotation of
the chuck can cause damage to the tool.
When the trigger switch is released it activates
the brake to stop the chuck quickly. This is
especially useful in the repetitive driving and
removal of screws.
GEAR SHIFTING
Your tool is equipped with two separate gear
ranges, Hi-torque and High-speed. Hi-torque
provides high-torque and slower drilling speeds
for heavy duty work or for driving screws. High-
speed provides faster speeds for drilling lighter
work. To change speeds slide switch, to the
Hi-torque or High-speed position (Fig. 1).
SITE-LIGHT™
Your tool is also equipped with a light that
turns on automatically when the switch is
activated for better visibility during operation
Operating Instructions
BRAKE
(Fig. 1). The Site-Light™ is maintenance free
and was designed to last the life of your tool.
INSERTING BIT
Move reverse switch lever to the center "OFF"
position. Disconnect battery pack from tool.
Viewing from chuck end, hold the chuck collar
firmly with one hand and rotate the chuck
sleeve counter-clockwise with the other hand
and open chuck to approximate bit diameter
(Fig. 2).
CHUCK COLLAR
FIG. 2
Clockwise
CHUCK SLEEVE
DRILLBIT
SCREWDRIVER BIT
For small bits, open jaws enough to insert the
bit up to the flutes. For large bits, insert the bit
as far as it will go. Center the bit as you close
the jaws by hand. This positions the bit
properly, giving maximum contact between the
chuck jaws and the bit shank.
To tighten, hold the chuck collar firmly with one
hand and securely tighten the chuck sleeve
clockwise with the other hand (Fig. 2).
Do not use the power of
WARNING
the drill while grasping
chuck to loosen or tighten bit. Friction burn
or hand injury is possible if attempting to
grasp the spinning chuck.
INSERTING AND RELEASING
BATTERY PACK
Release battery pack from tool by pressing
on both sides of the battery release tabs and
pull downward (Fig. 1).
To insert battery, align battery and slide
battery pack into tool until it locks into position.
Do not force.
-9-
Counter
clockwise
BIT HOLDER