Emf Measures; Specific Hazards - Fronius VR 1500-PAP Manual De Instrucciones

EMF measures

Electromagnetic fields may pose as yet unknown risks to health:
-
-
-
-

Specific hazards

Keep hands, hair, clothing and tools away from moving parts. For example:
-
-
-
-
-
Do not reach into the rotating cogs of the wire drive or into rotating drive components.
Covers and side panels may only be opened/removed while maintenance or repair work
is being carried out.
During operation
-
-
The welding wire emerging from the welding torch poses a high risk of injury (piercing of
the hand, injuries to the face and eyes, etc.).
Therefore, always keep the welding torch away from the body (devices with wirefeeder)
and wear suitable protective goggles.
Never touch the workpiece during or after welding - risk of burns.
Slag can jump off cooling workpieces. The specified protective equipment must therefore
also be worn when reworking workpieces, and steps must be taken to ensure that other
people are also adequately protected.
Welding torches and other parts with a high operating temperature must be allowed to
cool down before handling.
Special provisions apply in areas at risk of fire or explosion
- observe relevant national and international regulations.
Power sources for work in areas with increased electric risk (e.g. near boilers) must carry
the "Safety" sign. However, the power source must not be located in such areas.
Risk of scalding from escaping coolant. Switch off cooling unit before disconnecting coo-
lant flow or return lines.
Observe the information on the coolant safety data sheet when handling coolant. The
coolant safety data sheet may be obtained from your service centre or downloaded from
the manufacturer's website.
Use only suitable load-carrying equipment supplied by the manufacturer when transpor-
ting devices by crane.
-
-
-
Effects on the health of persons in the vicinity, e.g. those with pacemakers and hea-
ring aids
Individuals with pacemakers must seek advice from their doctor before approaching
the device or any welding that is in progress
For safety reasons, maintain as large a distance as possible between the welding
power-leads and the head/torso of the welder
Do not carry welding power-leads and hosepacks over the shoulders or wind them
around any part of the body
Fans
Cogs
Rollers
Shafts
Wirespools and welding wires
Ensure that all covers are closed and all side panels are fitted properly.
Keep all covers and side panels closed.
Hook chains or ropes onto all suspension points provided on the load-carrying
equipment.
Chains and ropes must be at the smallest angle possible to the vertical.
Remove gas cylinder and wirefeeder (MIG/MAG and TIG devices).
41