Storage; Accessories; Environment; General Information - Festool RG 130 ECI Manual De Instrucciones

English
Always use original Festool spare
EKAT
4
parts. Order no. at:
www.festool.co.uk/service
5
3
2
1
► To ensure constant air circulation, always
keep the cooling air openings in the housing
clean and free of blockages.
► Clean the sanding tools after use.
The tool is equipped with special self-discon­
necting carbon brushes. If they wear out, the
power supply is disconnected automatically and
the tool stops.
8.1 Cleaning the dust screen
To prevent the power tool from overheating, the
dust screen [6-1] must be cleaned regularly on
both sides (see figure [6]).
► Remove the dust screen. Use a screw­
driver as a levering tool if necessary.
► Extract the dust from the dust screen.
► Insert the dust screen.
9

Storage

The packaged power tool can be stored in a dry
place without heating as long as the inside tem­
perature does not fall below -5 °C.
The unpackaged power tool must only be stored
in a dry, enclosed space where the temperature
does not fall below +5 °C and where no extreme
temperature fluctuations can occur.
Store the insertion tools separately from the
power tool.

10 Accessories

Always use original Festool tools and accesso­
ries. Using low-quality tools or accessories
from other manufacturers may increase the
risk of injury and seriously unbalance the ma­
chine, decreasing the quality of the working re­
sults and accelerating power tool wear.
Refer to the Festool catalogue for the order
numbers of accessories and tools or find them
online at www.festool.co.uk.

11 Environment

Do not dispose of the device in the
household waste! Recycle devices, ac­
cessories and packaging. Observe appli­
cable national regulations.
EU only: In accordance with the European Di­
rective on waste electrical and electronic
equipment and implementation in national law,
used power tools must be collected separately
24
and handed in for environmentally friendly re­
cycling.
Information about collection points for correct
disposal is available at
recycling .
Information on REACH:
reach

12 General information

12.1 Information on data privacy
The power tool contains a chip which automati­
cally stores machine and operating data. The
data saved cannot be traced back directly to an
individual.
The data can be read in a contactless manner
using special devices and shall only be used by
Festool for fault diagnosis, repair and warranty
processing and for quality improvement or en­
hancement of the power tool. The data shall not
be used in any other way without the express
consent of the customer.
12.2 Information about Bluetooth
As soon as the tool is connected to the mobile
device via Bluetooth ®
tion has been authorised, the tool will connect
automatically to the mobile device from this
point onwards.
The Bluetooth ® word mark and the logos are
registered trademarks of Bluetooth SIG, Inc.;
they are used by TTS Tooltechnic Systems AG &
Co. KG, and therefore by Festool, under licence.
Imported into the UK by
Festool UK Ltd
1 Anglo Saxon Way
Bury St Edmunds
IP30 9XH
Great Britain
www.festool.co.uk/
www.festool.co.uk/
®
and the secure connec­