Joystick Installation And Operation; Power Up / Down; Emergency Stop - Moretti ARDEA MOBILITY VIRGO Manual De Instrucciones

18
If you need to replace the batteries, contact your retailer to obtain the correct replacement
batteries. Take care when replacing the batteries and do not discard depleted or damaged
batteries in the environment. Dispose of the replaced batteries at authorised recycling
centres and not in normal urban waste.

17. JOYSTICK INSTALLATION AND OPERATION

1. First read and fully understand this manual.
2. Mount all the electrical parts of the wheelchair system (motors, park brakes, batteries,
Power Module, Remote) on the wheelchair.
3. Do not connect any cables before all the parts of the electrical system are mounted.
4. Connect the LiNX LE System Power Module to the motors the park brakes and the Remote.
5. Connect the LiNX LE System Power Module to the batteries.
Note: Do not turn on the wheelchair yet.
WARNING!
Do not connect the positive terminal (B+) of the battery to the LiNX LE System
Power Module until the wheelchair is completely wired and ready for testing.
6. Lift the wheelchair off the ground and check the installation thoroughly.
7. Program the system to the requirements of a particular wheelchair or user.
8. Test the system for functionality and safety.

17.1 Power up / down

Note: In the unlikely event that the wheelchair is in a runaway situation, the user can press
the Remote's power button to perform an EMERGENCY STOP.
To switch ON the LiNX LE System, press the Power button. The Power button
is the only user input that can activate the system.
If the system is healthy, the Status indicator (through the Power button) will
light up green, and the Battery Gauge will display the current battery status.
If there is a fault with the system when powering up, the status indicator will
indicate the fault with a series of red flashes. If the fault is one that prevents
the system from driving, then the battery gauge will flash continuously.
To switch OFF the system, press the Power button; the system will power
down and the Status indicator will switch off.
The Power button is also used to perform an EMERGENCY STOP. See next
section.

17.2 Emergency stop

If the user needs to stop the wheelchair quickly, the Power button can be pressed to perform
an EMERGENCY STOP. The wheelchair will come to a halt quickly; the rate is set by the Emer-
gency Deceleration parameter.