When The Screw Stops During Operation - HUROM H-310A Serie Manual De Instrucciones

01 Open the hopper cover.
Pull the lever of the hopper cover to open it.
02 Add the juicing ingredients below the limit
mark of the hopper.
Use soft ingredients by mixing them with others.
Overloading the product with ingredients may
damage the product.
03 Close the hopper cover and keep the juice cap
open.
Before pressing the extraction button, put a cup
in place first.
The juice can flow backwards into the hopper if
the juice cap is closed. If the juice does not come
out even after opening the juice cap, then open
the hopper cover and remove the content.
04 Turn the power dial [ON] to start operation.
The "click" sound when the product is operating
is the sound of the chamber set and the motor
binding together.
Operation stops when the hopper cover is open.
05 During extraction, ingredients may get
stuck on the interior wall of the hopper or
cutting blades.
Turn the dial to the [REV] direction for 3 to 5
seconds to activate the reverse operation. Then,
turn the dial again to the [ON] direction. If the
movement of ingredients is not smooth, open the
hopper cover and organize the ingredients.
06 Let it operate for another minute or so after
the last ingredient goes down through the hopper.
It takes some time for the last piece to be juiced
as it slowly squeezes the ingredients.
If the remaining pulp is removed by additionally
running the machine after extraction, then it
should be quite easy to remove the hopper and
wash the parts.
07 Once the juicing and pulp removal are done,
stop the product by turning the power dial.
Even when it is stopped by the power switch, the
operation may stop after 3 seconds.
08 Pour any juice left by tilting the chamber set
forward.
For thick juice like tomato juice, it is likely to pool
in the chamber set.
8. When the Screw Stops during
Operation
01
02
01 For 2 to 3 times, repeat the process
of maintaining the state in which the
power dial is turned to the [REV] direction
(counterclockwise) for 3 to 5 seconds and
then releasing the dial. The reverse rotation
is a function that returns and lifts the
ingredients upward. It only works when the
dial is being turned, and the screw rotation
stops when the dial is released.
02
Note
If it does not work even after following the
above steps, unplug the power cord from the
outlet, remove the chamber set, wash it, and
use it again.
The motor will continue to spin after the
machine is turned off but it will slow down
and come to a complete halt.
11
OFF
REV ON
OFF
REV ON