cecotec ENERGYSILENCE AERO 5200 Manual De Instrucciones página 22

ENGLISH
4. Rotation inversion L (grey)
3. L light (blue)
2. L fan (black)
1. N (white)
5. Rotation inversion
4. Green/yellow stripe
3. L light (blue)
2. L fan (black)
1. N (white) Neutral
Receiver
Warning:
2 people are needed to carry out the cable connection step. It is suggested that 1 person
holds the assembled device while the other one connects the cables.
Canopy assembly
Fig. 8.
1. Raise the canopy to the mounting bracket, aligning the loosened screws in the mounting
bracket with the holes in the canopy.
2. Twist the canopy until both screws safely hold the device, reinsert the screws and tighten
them with a screwdriver.
Note:
For safety reasons, it is suggested that 1 person holds the stepladder during this step.
Blade assembly
Fig. 9.
- Time-saving tip: Washers for blade screws can be set on each blade screw prior to
installing blades.
- Align blade holes with motor screw holes, securing tighten all the screws once all the
blades are attached. Before securing screws permanently, repeat with remaining blade
arms.
Note:
Tighten blade screws twice a year.
LED lamp support
Fig. 10.
1. Unscrew the motor plates' screws and tidy all the cables placing them in their position.
Align the holes on the back part of the LED pan with the 3 screws on the motor's plate.
42 ENERGYSILENCE AERO 5200 WHITE/BLACK LINE
1. Fig. 11.
2. Then, screw the 3 screws on the LED plate's holes and make sure that the light set is fixed
and does not move.
Place the cover and the lamp again on the LED.
Glass shade assembly
Fig. 12.
Restore the cover and the lamp shade back to the LED pan, and secure them with decorative
clips and bolt nuts.
4. OPERATION
Fig. 13.
1. Speed control
2. Off button
3. Lamp
4. Timer
5. Winter/summer function (blade spinning inversion)
- The indicator will light up while the product is operating.
- Use the 3 speed buttons to select the air power level: low, medium or high.
- Press the off button to turn the device off.
- Use the 4 timer buttons to select the fan's operation time: 1, 3, or 8 hrs. The fan will turn
off once the selected time has elapsed.
- Press the light button to turn the fan's lamp on and off.
- The remote control requires 2 x 1.5 V-3AAA batteries.
- Winter function: if it is cold, press for blades to move hot air stuck close to the ceiling
around.
- Summer function: if it is hot, press again for blades to create a refreshing breeze.
Warning:
Invert the fan's spinning direction while it is operating. Hold down the button for approx. 3
seconds, the device will beep, and the blades will start slowing down until they practically
stop spinning. After a few seconds, they will start spinning again in the opposite direction.
Warning:
- The remote control operates through RF Wireless digital transmission technology. If both
the fan and the lamp are equipped with switch, turn on the fan at top speed and turn the
light on before using the remote control.
ENGLISH
ENERGYSILENCE AERO 5200 WHITE/BLACK LINE 43