Idiomas disponibles
Idiomas disponibles
KUKKO 67-1 and 67-2
• Remove the McPherson spring strut.
• Select jaws according to table (page 22-36) and mount on the spring compres
sor. Fit the retaining bolts and tighten firmly. It is very important for
!
your safety that the bolts of the jaws are firmly tightened.
• Rotate the drive nut to drive the jaws apart to match the length of the spring
and to compress as many windings as possible.
• Place the coil spring compressor in the built-in protective accessory in a suita-
ble vice.
• Place the spring strut onto the coil spring compressor. Take care that the se-
ating of the spring windings in the jaws is correct.
• With an impact wrench or a racket spanner, turn the drive nut until the upper
support bearing is free. Additional compressing is permit-ted.
When using impact wrench do not exceed 180Nm
!
torque limit.
• Use the raised jaw 67-01 to ensure that the centre line of the spring is parallel
to the compressing device. Do not use the coil spring compressor for conical
springs if this is not the case. Fit the raised jaw 67-01 at the spring end with
the smallest diameter.
It is very important for your safety that the jaws are fitted correctly
!
and that the bolts are firmly tightened before use.
• Use the raised jaw 67-01 to ensure that the centre line of the spring is
parallel to the compressing device. Do not use the coil spring compressor
for ball springs if this is not the case. Fit raised jaws 67-01 at both spring
ends.
It is very important for your safety that the jaws are fitted correctly
!
and that the bolts are firmly tightened before use.
Operation Advice
Conical Springs
Ball Springs
8
