BH FITNESS G260 Instrucciones De Montaje página 12

Fig.1 Parts list
(1) Monitor.
(4) Main post.
(44) Handlebar stem.
(72) Main body.
(146) Bottle holder.
(149) Bracket cover.
(150) Focus bar spindle covers (L).
(151) Focus bar spindle covers (R).
(152) Covers main post right (R).
(153) Covers main post left (L).
Fig.2 Screws and fasteners
(154) Allen screws M-8x55.
(155) Screws M-3x16.
(156) Self locking nuts M8.
(157) Washers M8 Ø 16.
(158) Allen screws M-8x20.
(159) Washers M8 Ø 16.
Combination box spanner.
Allen key.
2. FITTING THE MAIN POST.-
Take the main post (4) and remove
the screws (15)
washers (16) and spring washers (17)
from the bottom of the post. Fig.3.
Next, bring the main post (4) up to
boss (D) on the main body (72), Fig.3,
connect the terminals (73) and (19),
Fig.3.
Slip the main post (4) over the boss
(D) on the main body (72) in the
direction of the arrow, Fig.3, making
sure not to snag any of the cables.
Refit the screws (15), the washers
(16) and the spring washers (17) that
you removed previously, and tighten
securely.
ATTENTION: It is advisable to
retighten these screws after one
month of using the machine.
the corrugated
3. FITTING THE FOOT BARS.-
Take the left foot bar (50) and position
it on the "U" at the bottom of the left
focus bar (20), Fig.4.
Insert screw (154), as shown in
Fig.4A, then fit the flat washer (157)
and the self locking nut (156), and
tighten securely.
Take the right foot bar (61) and go
through the same assembly procedure
as with the left.
4. FITTING THE FOCUS BAR
SIDE COVERS TO THE FOOT
BARS.-
Take the covers (150 and 151),
marked on the inside with the letter
"R", and position them at the end of
the foot bars with the inside of the
focus bars on the right hand side, as
shown in Fig.5. Now use screws (155)
to attach them.
Carry out the same procedure using
the covers (150 and 151) marked on
the inside with the letter "L".
Next, release the screws (5 and 9) of
the main post (4), take bottle holder
(72), and insert it in through the top of
the post (4) in the direction of the
arrow. Attach the bottle holder using
screws (5 and 9) previously removed.
5. FITTING THE HANDLEBAR.-
Bring the handlebar (44) up to the
handlebar stem (4), Fig.7, insert the
hand-grip cable (49) in through the
slot as shown in Fig.7, and pull it out
through the top of the handlebar stem.
Insert screw (158), put the washer
(159), then fit the bracket cover (149).
12