IMPORTANT: Be certain to charge the battery for at least 14 hours
before operating your mower. Refer to Operation section.
NOTE: Stand behind the mower as if you were going to operate it.
Your right hand corresponds to the right side of the mower; your left
hand corresponds to the left side of the mower.
LOOSE PARTS IN CARTON
The following items are packaged loose in the carton:
Operator's Manual, Grass Catcher
REmOVING THE UNIT FROm THE CARTON
1.
Cut the corners of the carton and lay the sides flat on the ground.
Remove all packing inserts.
2.
Move the mower and grass catcher out of the carton.
3.
Make certain the carton has been completely emptied before
discarding it.
ASSEmbLING THE HANDLE
1.
Remove any packing material which may be between upper and
lower handles.
2.
Loosen each hand knob found on the inside of the upper handle.
3.
Gently lift and pivot the upper handle into the operating position
as shown in Figure 1.
4.
Remove star knobs from handle mounting brackets and secure
the lower handle onto the handle brackets by placing the lower
hole of the lower handle onto the pins of the handle brackets.
5.
Secure the upper handle and lower handle by tightening the
hand knobs. Each carriage bolt must be seated properly into the
square hole found in the plastic connector.
6.
Tighten star knobs securing lower handle to handle brackets. See
Figure 2. Make certain the lower handle is seated securely into
the handle mounting brackets.
ATTACHING THE GRASS CATCHER
1.
Lift rear discharge door.
2.
Remove mulching baffle. See Figure 3.
ASSEMBLY
8
Figure 1
Figure 2
Figure 3