Craftsman 247.370480 Manual Del Operador página 14

Circuit Breaker
Reset Button
WARNING
Due to a potential shock hazard, DO NOT attempt to remove the
motor/battery shroud. There are no user serviceable parts inside.
Contact your nearest Sears Service Center if repairs are needed.
WARNING
Always stop the motor and remove key before cleaning, lubricating
or performing any repairs or maintenance on the lawn mower. Always
wear safety glasses during operation or while performing any adjustments
or repairs.
Interval
Each Use 1.
2.
3.
4.
5.
Annually or 25 hours 1.
2.
3.
Before Storage 1.
During Storage 1.
SERVICE AND MAINTENANCE
Figure 13
mAINTENANCE SCHEDULE
Item
Mower blades
Loose or missing hardware
Controls
Motor
Deck
Wheels
Rear discharge door and
side mulch plug
Mower blades
Battery
Battery
RESETTING CIRCUIT bREAkER RESET
bUTTON
This mower is equipped with an circuit breaker reset button to prevent
overheating damage to the motor.
If the circuit breaker reset button pops out:
1. Release the motor/blade control handle and do NOT re-start the
mower for at least one minute, allowing for the motor time to cool.
2. Press the circuit breaker reset button inward to reset. See Figure
13.
If the circuit breaker reset button pops out shortly after resetting:
1. Release the motor/blade control handle and do NOT re-start the
mower for at least 15 minutes to allow the motor extra time to cool.
2. Press the circuit breaker reset button inward to reset.
3. Restart unit.
NOTE: If the circuit breaker reset button pops out repeatedly during
operation or will not remain in when attempting to reset, contact your
nearest Sears Service Center to arrange for repair.
bATTERY CARE
IMPORTANT: Replace with only the identical battery provided with this
mower (Part number 725-04381). The battery should only be replaced
by a Sears Service Center.
Follow the maintenance schedule given below. This chart describes
service guidelines only. Use the Service Log column to keep track of
completed maintenance tasks. To locate the nearest Sears Service
Center or to schedule service, simply contact Sears at
1-800-4-MY-HOME®.
Service
1. Sharpen as required
2. Tighten or replace
3. Check for proper operation
4. Remove any buildup of grass and
leaves on or around the motor cover
(do not use water).
5. Clean underside of deck with a
suitable tool (do not use water).
1. Lube with light oil
2. Lube torsion spring and pivot point
with light oil.
3. Sharpen and balance
1. Fully charge
1. Charge every two months
14
Service Log