MESTIC RTA-2500 Instrucciones De Uso página 23

The following step by step instructions must be performed in the following sequence to ensure proper installation.
1. Carefully take the ceiling assembly out of the carton
(The remote control packed with the ceiling assembly).
2. Remove the ceiling grille from the ceiling assembly.
3. Before installing the outdoor unit of recre- ational
vehicle air conditioner on the vehicle's top,
preinstall the plate of air vent and foam (upper) on
the chassis of the outdoor unit with 4pc of screws
(25mm long) (See fig.5-1) .
4. Then carry the outdoor unit to the vehicle's top
and align with the openings on the vehicle's top.
Use 2 sets of mounting plate assembly and 4
screw bolts to mount the outdoor unit (See fig. 5).
You must start (thread) themounting bolts by hand
to avoid cross-threading. DO NOT START THE
MOUNTING BOLTS WITH AN AIR GUN. The mounting
bolts should be tightened, process is completed when
Thickness of vehicle
roof is from 30mm-80mm
Gasket
4 bolt
(Max torque
is from
2.3Nm~2.5Nm)
Figure 5
4 bolt
Sponge
(Num3,5mm)
Figure 5.2
Installtion board
Bubble
Wind-path
Foam
(Num3,14mm)
Foam
Foam(under)
the basepan gasket has been evenly compressed.
5. Before installing the air duct assembly of the
indoor unit of recreational vehicle air conditioner,
assemble the foam assembly according to the
thickness of the vehicle's top. After simulated
installation, use
sponge and foam assembly. Stick the sponge
and foam assembly with double faced adhesive
tape (prepared by user) (See fig.5-2, 5-3)..
6. Install the foam assembly on the air duct assembly.
Use 4 screw bolts to fix the air duct assembly onto
the mounting plate. After connecting the outdoor
unit with indoor unit, check whether the foam
assembly has come loose (See fig.5).
Gasket
Figure 5.1
4 screw
Figure 5.3
an appropriate amount
Outdoor Unit
Foam (top)
Plate of air vent
Foam
Wind-path
of
23